NetSetMan Support

eisner

New Member

Registered: 2024-07-20

Posts: 1

BSSID Automaticlly set

Apologies if the answer to this question is obvious, but I am new to NetSetMan.

I am using the program to connnect my Win 11 desktop to a particular mesh unit on my home wifi using the BSSID.  I have set up a profile so that one click does this.  However, when I reboot the PC, it loses connection with the desired BSSID.  How do I get the  program to run automatically at boot up?

NetSetMan Support

Administrator

Registered: 2005-08-06

Posts: 1,878

Re: BSSID Automaticlly set

There is an option to automatically start the application with Windows in the Preferences > General.
This only runs the application.

If you want to automatically apply a profile, you can use the AutoSwitch feature and configure some condition that is true at that location. In your constellation, you might want to enable the option "At program startup, check conditions regardless of last profile activation" so the profile is applied even if it was already applied before your reboot.