NetSetMan Support

UWK-87

Member

Registered: 2017-07-13

Posts: 11

Issue with AutoSwitch Conditions

Hi,

I might be setting this up wrong but what I am trying to do is if I am already connected to a certain SSID and if it disconnects, then connect me to a pre-selected SSID. Below are the screenshots for the rules.

CONDITION: DISCONNECTED from "MyMobile" SSID
CONNECT TO: WAR

So when I am disconnected from MyMobile nothing happens at all. Tried on two different machines with different SSID configurations.

Thanks

NetSetMan Support

Administrator

Registered: 2005-08-06

Posts: 1,878

Re: Issue with AutoSwitch Conditions

Please first make sure to read the details about AutoSwitch here:
http://www.netsetman.com/en/help?hf=en#hf_autoswitch
and here:
http://www.netsetman.com/en/faqautoswitch

AutoSwitch ist meant to switch between profiles based on changing conditions. It is not meant to activate the same profile over and over again.

In your case, if "SET1" (you know you can rename profiles, don't you?) is already the last activated profile, then it won't be activated again. See the two links above for more details on this.

What you might want to do is to adjust the WiFi profile "WAR". Enable its option "Connect when this network is in range". You can do this in our NSM WiFi Management.
In case "MyMobile" should have a higher priority, you might want to reorder the WiFi profiles in the list by drag-and-drop. Windows will prefer the profiles at the top over the profiles at the bottom.