NetSetMan Support

jessehouwing

Member

Registered: 2014-11-26

Posts: 2

Windows 10 - Enabling connect to wifi breaks connection

I have a few issues on Windows 10 10240, the primary problem is that when I enable connection to a wireless profile, the switch will succeed, but the network interface will never get a proper IP address. I have to disable/enable the wireless interface for the connection to work again.

The other issue I have is that when I'm already connected to the right wireless access point (or the IP settings already match the proposed settings, that NetSetMan Pro changes them anyway, causing a short network disruption. If the correct access point is already connected or the right network settings are already applied, the changes can be ignored.

NetSetMan Support

Administrator

Registered: 2005-08-06

Posts: 1,878

Re: Windows 10 - Enabling connect to wifi breaks connection

1. Could you please verify that this issue still exists with the final version? (released today)
What are the initial settings, and what are the settings you're trying to apply?

2. We share your opinion on that and will implement that in one of the next versions.