NetSetMan Support

athompso

Member

Registered: 2015-01-04

Posts: 2

IPv6 manual config non-functional

When attempting to configure a manual IPv6 address, it is impossible to add valid IPv6 addresses to any of the entry fields - I can't type colons (:), only periods (.) as punctuation, and I can't find any valid format that is accepted.

I *should* be able to enter "2620:42:c000:1::23" as the manual IP, "2620:42:c000:1::1" as the gateway and "2620:42:c000:1::8" and "2620:42:c000:1::9" as the DNS servers, but I cannot.

I'm running 3.7.3 (2014-06-03) under Windows 8.1 Pro x64.

How do I proceed?  IPv6 autoconfiguration is not fully functional on this subnet, so I must enter the values manually.

Thanks,
-Adam

athompso

Member

Registered: 2015-01-04

Posts: 2

Re: IPv6 manual config non-functional

Also, Profile-->Get Current Settings does not copy the current IPv6 settings.

NetSetMan Support

Administrator

Registered: 2005-08-06

Posts: 1,878

Re: IPv6 manual config non-functional

Having read your comment I'm not sure where exactly you're trying to enter the IPv6 addresses in our program. Did you notice the special IPv6 section (last item on the right side of the main UI)?
Also please have a look at the corresponding FAQ section:
www.netsetman.com/faqipv6